User Setup
Chapter
24
Source Patch
The source patch is a function whereby signal pairs
recorded in applicable data are automatically converted to
use key snapshots, snapshots, and keyframes in different
switcher systems as is.
Sequence of Source Patch
Operations
In the following description, two different switcher
systems are referred to as Switcher A and Switcher B.
In Switcher A, assign a name (user source name) to each
signal pair.
r
Export the user source name file to a memory card.
r
In Switcher B, import the user source names from the
memory card.
r
Create a signal pairs conversion correspondence table
(patch table).
r
In Switcher B, recall the snapshot, key snapshot, or
keyframe file created in Switcher A (signal pairs are
replaced according to the patch table).
Exporting a User Source Name File
to the Memory Card
In Switcher A, use the following procedure.
1 In the User Setup menu, select VF1 ‘Source Patch’ and
HF1 ‘User Source Name.’
The User Source Name menu appears.
2
Use either of the following methods to select the target
pair in the list on the left.
•
Press directly on the list in the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
3
Press [Usr Src Name] outside the list.
The keyboard window appears.
4
Enter a name of not more than 16 characters, and press
[Enter].
The name you have entered is reflected in the Usr Src
Name area.
5
Repeat steps 2 to 4, to set all of the necessary names.
6
Press [File >Exp Usr Src Name].
The Export Usr Src Name menu appears.
7
Select Memory Card as the destination, and press
[t
Export].
To Next Page
Loading...
