Overall Control Panel Settings (Config Menu)
Select the
position of the
bank you want to
set
Chapter
19
Control
Panel
Setup
(Panel)
Control Panel Setup
(Panel)
Chapte
1
r
9
Overall Control Panel
Settings (Config Menu)
To carry out the overall control panel settings, use the
Panel >Config menu.
To display the Config menu
In the Engineering Setup menu, select VF2 ‘Panel’ and
HF1 ‘Config.’
The status area shows the location numbers of the M/E and
PGM/PST banks, the allocated bank names, and whether
or not operation is enabled.
to. You can set the links between keyers for each M/E
bank separately.
•
Joystick/Trackball User Setting: When a trackball
module and a joystick module are both connected as
device control blocks, select which is used as the
reference. Also select whether key wipe positioning
applies to keys 1 to 8, or to keys 1 to 4.
•
10 Key Region Assign: Assign any regions to the region
selection buttons in the numeric keypad control block.
Also used for setting the regions included in the selection
when the [ALL] button is pressed.
•
Program Button: Make assignments for buttons of
some control blocks such as assigning the buttons in a
transition control block for controlling a VTR and
assigning the Flexi Pad control block to macro
operation.
• Compact Key Module Assign: You can select which
Panel Setup
In panel setup, you carry out settings particular to the
control panel.
You can make the following settings.
Panel settings (Config)
•
M/E Assign: Set the logical configuration of the M/E
and PGM/PST banks.
•
M/E Operation: For each of the M/E and PGM/PST
banks, make operations possible, not possible, or
disabled (Enable/Disable/Inhibit).
•
Dual M/E Assign: Using two M/E banks, assign the
shift and non-shift button rows of a single M/E bank.
•
Dual M/E Xpt Swap: When a setting has been made for
Dual M/E Assign, swap the shift and non-shift button
rows.
•
DSK Fader Assign: Carry out fader function
assignment and key delegation for the key delegation
buttons, in each of the maximum of four downstream
key control blocks.
•
External Bus Link: Make link settings relating internal
switcher buses to routing switcher destinations.
•
Key Trans Link: Select whether or not to link
transitions between keyers, and if so which keyer to link
keys can be operated with an independent key transition
control block (simple type).
•
M/E Operation Inhibit: For each M/E or PGM/PST
bank, enable or inhibit utility 2 bus-related and key-
related operations.
•
Joystick/Trackball Module: Enable or inhibit DME
channel selection operations from the device control
block (trackball) or device control block (joystick).
Interchanging the Bank Order or
Disabling Operation
1 In the Panel >Config menu, select the Bank you want
to set, using any of the following methods.
•
Press directly on the status area display.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
To Next Page
Loading...
