Chapter
3
Signal
Selection
and
Transitions
•
When the transition type is NAM, the outputs of the A
bus and B bus in the above table are the outputs
subjected to NAM.
•
The transition indicators always show the progress of the
background A bus.
•
The operation of the left lever and that of the right lever
can be swapped.
For details, see “Specifying Main Split Fader” in
Chapter 19 (Volume 2).
Independent Key Transitions With a
Simple Transition Module
You carry out independent key transition operations using
the independent key transition control block (simple type).
This controls only keys 3 and 4. However, each key button
can be assigned to any key in setup.
For details, see “Assigning a Function to the Independent
Key Transition Control Block (Simple Type)” in Chapter
19 (Volume 2).
Key 3 control block Key 4 control block
Carrying out a transition using a simple-
type independent key transition control
block
1
Select the transition type for key 3 or key 4 using the
independent key transition type selection buttons.
To fade a key in or out: Press the [MIX] button,
turning it on.
To insert or delete a key using a dedicated wipe
pattern: Press the [WIPE] button, turning it on.
To insert or delete a key using a dedicated DME
wipe pattern: Press the [DME] button, turning it
on.
For details of wipe settings, see “Wipe Settings for
Independent Key Transitions” (page 175). For details
of DME wipe settings, see “DME Wipe Settings for
Independent Key Transitions” (page 193).
To cut the key instantaneously in or out: Press the
[CUT] button, turning it on.
If, in the Setup menus, you set insertion and deletion
as independent modes, make the settings for the next
transition in the independent key transition control
block.
Separate settings are required both when inserting a
key and when deleting it. For example, with the key
not inserted, if you select the transition type and carry
out a transition, this will be the setting when inserting
a key.
2
Carry out the transition in the independent key
transition execution section.
To insert or delete the key gradually with a mix or
wipe transition: Press the [TAKE] button.
To set the independent key transition rate using a
simple-type transition control block, use the key 3
and key 4 Transition menus (see page 117).
To cut the key in or out instantaneously: Press the
[KEY 3 ON] button or [KEY 4 ON] button.
Independent key transition
execution section
Independent key transition type
selection buttons
The functions of the key 3 control block and key 4 control block
are the same.
Notes
In an independent key transition, the pattern limit
function is not available.
Independent key transition control block (simple type)
To Next Page
Loading...
