Serial Tally Settings (Serial Tally Menu) 659
Chapter
23
Setup
Relating
to
Router
Interface
and
Tally
(Router/Tally)
3
Using any of the following methods, select the port bit
number.
•
Press directly on the list on the left of the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
4
Turn the knob to select the source address.
5
Press [Source Address Set].
Clearing a Source Address Setting
To clear a source address setting for a particular
bit
In the Router/Tally >Serial Tally >Source Assign menu,
select the serial tally port and bit number (see steps 2 and
3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Router/Tally >Serial Tally >Source Assign menu,
select the serial tally port, then press [All Clear].
A confirmation message appears.
•
If you select “Yes,” this clears all source address settings
for the selected serial tally port.
•
If you select “No,” the clear operation is canceled.
To return all source address settings to the
default
In the Router/Tally >Serial Tally >Source Assign menu,
select the serial tally port, then press [Default Recall].
A confirmation message appears.
•
If you select “Yes,” this returns all source address
settings for the selected serial tally port to the default.
•
If you select “No,” the operation is canceled.
To Next Page
Loading...
