Replacing Signal Pairs Using the
Patch Table
The source patch is effective for key snapshots, snapshots,
and keyframes.
The following describes the operation for a snapshot as an
example.
Copy a snapshot file created in Switcher A to the memory
card in advance.
1
In the Patch Table menu, press [File >Snapshot].
The File menu appears.
Src Patch Link button
2
In the list on the right, select the file you want to recall
to the register.
3
Press [Src Patch Link] to turn it on.
4
Press
[
T
Load].
The snapshot of which signal pairs have been replaced
according to the patch table is recalled to Switcher B.
To Next Page
Loading...
