Sony MVS-8000X SystemMVS-7000X System - Page 55

USO RESTRITO
Names and Functions of Parts of the Control Panel 55
Name
Description
ALL
• Select all regions.
• When any region is already selected,
pressing this button makes all regions
unselected.
M/E 1 to
M/E 5, P/P
Select the corresponding regions, M/E-1,
M/E-2, M/E-3, M/E-4, M/E-5, and PGM/PST.
For details of [M/E 4] or [M/E 5] button
assignment, see “Assigning a Button for M/E-
4 or M/E-5 Selection in the Setup Menu”
(page 396) in Appendix.
USER 1 to
USER 8
Select a User region.
DME1 to
DME8
Select a DME channel.
P-BUS
Select the P-Bus region.
GPI
Select the GPI region.
RTR
Select the router region.
DEV1 to
DEV12
Select the Device 1 to Device 12 regions
respectively.
MCRO
Select the macro region.
Name
Description
0 to 9
Used to input numeric digits.
. (period)
• Enters the decimal point.
• When the [TC] button is lit, enters “00.”
• When the [EFF] button, [SNAPSHOT]
button or [SHOTBOX] button is lit, this is
used to find an empty register.
+/–/EFF
DISS (effect
dissolve)
• Invert the sign, negative or positive.
• When the [SNAPSHOT] button is lit, applies
the effect dissolve attribute to a snapshot.
CLR/AUTO
TRANS
(clear/auto
transition)
• Clear an input value, returning to the
previous state.
• When the [SNAPSHOT] button is lit, applies
the auto transition attribute to a snapshot.
TRIM/GPI
ENBL
(enable)
• After entering a difference value to be
added to an existing setting, press this
button to confirm the change.
• When the [SNAPSHOT] button is lit, adds a
GPI output attribute to the snapshot.
ENTER
Confirm an entered value.
Name
Description
UNDO
After recalling a register, press this button to
return to the state before recalling the register.
STORE
STATS
(store
status)
• This lights amber when data is stored in a
register.
• After saving data to a register, hold down
this button and press the [UNDO] button to
return the register to the state before the
data was saved.
TC
(timecode)
Press this button, turning it on, to switch
transition rate entry to the timecode entry
mode.
STORE
a)
Press this button to switch to the mode for
saving a snapshot, effect, shotbox or macro in
a register.
Chapter
2
Menus
and
Control
Panel
Name
Description
RCALL
(recall)
a)
Press this button to switch to the mode for
recalling a snapshot, effect, shotbox or macro
from a register.
c Function selection buttons
The following buttons are used to switch the function.
a) [STORE] button or [RCALL] button flashes amber when one or more of
the regions assigned to the Region selection buttons are not selected by the
Region Select menu.
d Numeric keypad
In addition to the buttons for numeric input, this includes buttons for adding attributes to snapshots.
e Display
This shows the selected region name, register number, and
entered numeric values.