Change
aspect ratio
vertically
Change
aspect ratio
horizontally
and
vertically at
a time
Parameter group [2/2]
Device control block operations for key
shrinking, magnification, rotation and
movement
Delegation buttons
RSZR CTRL button
Trackball
4
To specify the direction of rotation, press the [ROT X]
or [ROT Y] button, turning it on.
Notes
To enable the [ROT X] and [ROT Y] buttons, it is
necessary to assign functions in advance.
For details, see “Assigning Functions to Key Control
Block Buttons” in Chapter 19 (Volume 2).
5
Turn the knobs to adjust the following parameters.
ROT button
RSZR button
Z-ring
LOC button
•
When [ROT X] is lit
•
When [ROT Y] is lit
ASP button
1
Press the [RSZR CTRL] button, turning it on.
2
Press the delegation button to select the key.
3
Press the [RSZR] button, turning it on.
4
• To change the aspect ratio, turn on the [ASP] button.
•
To shrink, magnify, or move the key, turn on the
[LOC] button.
•
To rotate the key, turn on the [ROT] button. To
specify the direction of rotation, press [X] or [Y]. To
adjust perspective, press [Z].
Hold these buttons down while carrying out the
operation of step 5 to enable fine adjustment (fine
mode).
5
Use the trackball and joystick for the operation.
For details of parameters, see steps 3 and 5 of “Key
control block operations for key shrinking,
magnification, rotation and movement” (page 153).
Entering parameters
This operation is the same as DME three-dimensional
parameter input.
For details, see “Entering Three-Dimensional Parameter
Values” (page 286).
To Next Page
Loading...
