Key source name display/key
snapshot buttons
The functions of the key 3 control block
and key 4 control block are the same.
Key 3 control block Key 4 control block
Notes
If you save a key snapshot in a register for which the
button is lit orange or yellow, the existing contents of
the register are overwritten.
K-SS button
In setup, assign the function of
the K-SS 3/4 button to any of
these four buttons.
Recalling a key snapshot
For example, the following procedure recalls the state of
the M/E-1 key 3 settings.
1
In the M/E-1 independent key transition control block,
press the [K-SS] button in the key 3 control block,
turning it on.
2
Press the key source name display/key snapshot button
corresponding to the register you want to recall.
Press the [K-SS 3/4] button as required, to switch
between displaying the key 3 registers 1 and 2 or
registers 3 and 4.
The button you pressed lights yellow, and this recalls
the key settings (excluding the key insertion state (on/
off) and key priority).
Independent key transition control block (simple type)
Saving a key snapshot
For example, to save the settings of M/E-1 key 3, use the
following procedure.
1
In the M/E-1 independent key transition control block,
press the [K-SS] button in the key 3 control block,
turning it on.
This switches to key snapshot mode, and the key
source name display/key snapshot button shows the
state of registers 1 and 2 for key 3.
Pressing the [K-SS 3/4] button shows the state of
registers 3 and 4 for key 3.
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
For a register holding a snapshot, the register name is
shown as up to eight characters.
2
In the Flexi Pad control block, hold down the
[SNAPSHOT] button and press the key source name
display/key snapshot button corresponding to the
register in which you want to save the snapshot.
The key source name display/key snapshot button
which you pressed lights yellow.
To Next Page
Loading...
