DME Wipe Settings for Independent Key Transitions
Crop the left
and right of the
image
Crop the top
and bottom of
the image
Crop the top,
bottom, left,
and right of the
image
Setting the DME wipe pattern size (Size)
For applicable pattern numbers, see page 186.
1
In the Key 1 DME Wipe Adjust menu, press [Size],
turning it on.
2
Set the following parameter.
a)
The effect size when [Size] is off is taken as 100.00%.
Cropping a key DME wipe
1
In the <Crop Mode> group of the Key1 DME Wipe
Adjust menu, press [Crop], turning it on.
2
Set the following parameters.
Parameter group [1/2]
To set the operation for DME wipe crop transition
execution
1
In the <Crop Mode> group of the Key1 DME Wipe
Adjust menu, press [Crop], turning it on.
2
In the <Crop Mode> group, press [Crop] or [4:3 Crop]
(to crop to 4:3 in 16:9 mode), turning it on.
3
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu appears.
For subsequent operations, see step 5 of “To set the
action when a DME wipe crop transition is executed”
(page 191).
To set the timing of transition completion
1
In the <Crop Mode> group of the Key1 DME Wipe
Adjust menu, press [Crop], turning it on.
2
In the <Crop Mode> group, press [Remove From
Begin].
For subsequent operations, see “Setting the timing of
transition completion” (page 192).
Applying a border to a key DME wipe
In the <Edge> group of the Key1 DME Wipe Adjust menu,
press [Border], turning it on.
For subsequent operations, use the same process as in step
4 of “Modifying the DME wipe pattern edge” (page 189).
Parameter group [2/2]
Cropping of the
top of the
image
Cropping of the
left of the
image
Cropping of the
right of the
image
Cropping of the
bottom of the
image
To crop to 4:3 in 16:9 mode
In the <Crop Mode> group, press [4:3 Crop], turning it on.