Sony MVS-8000X SystemMVS-7000X System - Page 267

USO RESTRITO
M/E Configuration Switching 267
Chapter
10
Special
Functions
2 In each of the <M/E Split (1st Board)> to <M/E Split
(3rd Board)> groups, select one of [1ME] to [4ME].
For no assignment to any M/E, select [Disable].
3 Press [Execute].
Restrictions in 3M/E mode and 4M/E mode
In 3M/E mode and 4M/E mode, the following restrictions
apply.
Classification
3M/E mode
4M/E mode
Operation mode
All M/Es and
P/P
DSK mode and multi-program 2
mode cannot be set.
All M/Es and
P/P
• DSK mode and multi-program 2
mode cannot be set.
• [Utility 2] cannot be selected for
the background in multi-program
mode.
M/E-1, M/E-2
[Utility 2] cannot be selected for the
background in multi-program mode.
M/E assignment
All M/Es and
P/P
Logical M/E Assign cannot be used.
All M/Es and
P/P
Logical M/E Assign cannot be used.
Wipes
All M/Es and
P/P
• Pattern mix cannot be used.
• Pattern number 162 wipes cannot
be used.
All M/Es and
P/P
• Pattern mix cannot be used.
• Pattern number 162 wipes cannot
be used.
M/E-2
• Random/diamond dust wipes can
be used.
• Dust mix cannot be used.
M/E-2, M/E-3
• Random/diamond dust wipes can
be used.
• Dust mix cannot be used.
Wipe border
M/E-2
Wipe border colors are single-color
only.
M/E-2, M/E-3
Wipe border colors are single-color
only.
M/E outputs
M/E-1, M/E-2
Out5 and Out6 cannot be used.
All M/Es and
P/P
Out5 and Out6 cannot be used.
Signal selection
M/E-1, M/E-2
PROC V and PROC K signals
cannot be selected with any cross-
point button.
All M/Es and
P/P
PROC V and PROC K signals
cannot be selected with any cross-
point button.
Utility bus
M/E-1
Since only one utility bus is available,
utility 1 bus is used instead of utility 2
bus in the following functions.
a)
• Wipe border
• Preset color mix
• Backgrounds of DME wipes
M/E-1, P/P
Since only one utility bus is available,
utility 1 bus is used instead of utility 2
bus in the following functions.
• Wipe border
• Preset color mix
• Backgrounds of DME wipes
M/E-2
Since only one utility bus is available,
you cannot select the following
functions.
• Key border
• Sub mask
• Preset color mix
• Wipe border
M/E-2, M/E-3
Since only one utility bus is available,
you cannot select the following
functions.
• Key border
• Sub mask
• Preset color mix
• Wipe border
M/E-2
If you select a DME wipe which uses
a utility bus for a background image,
a color matte signal is used instead
of a utility bus signal.
M/E-2, M/E-3
If you select a DME wipe which uses
a utility bus for a background image,
a color matte signal is used instead
of a utility bus signal.