Chapter
13
Keyframe
Effects
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in that order. Similarly, to
search for an empty register in the 200 range, press [2],
[0], [0], [.] (period), and to search for an empty register
in the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the
number is followed by a letter “e” or “E,” this indicates
the following.
e: The selected register is empty for the regions
selected in step 2.
E: The selected register is empty for all currently
selectable regions.
4
Press the [ENTER] button.
This recalls the specified register.
When the master timeline is recalled, the region
selection buttons light according to the saved region
information.
To recall the master timeline
1
In the Multifunction Flexi Pad control block, press the
[EFF] button.
This switches the Multifunction Flexi Pad control
block to the effect operation mode.
2
Press the [MSTR RCLL] button.
This switches the memory recall section to the master
timeline recall mode.
3
Press the [BANK SEL] button.
This switches the memory recall section to the bank
selection mode.
4
Press the number of the desired bank.
This selects the bank, and the buttons in the memory
recall section show the register states as follows.
Lit yellow: Last recalled register
Lit orange: Register holding data
Off: Empty register
5
Press the number of the desired register.
The button you pressed lights yellow, and this recalls
the master timeline.
The alphanumeric display shows the selected register
number.
To Next Page
Loading...
