Overall Control Panel Settings (Config Menu) 571
Chapter
19
Control
Panel
Setup
(Panel)
•
Press the arrow keys to scroll the reverse video
cursor in the list in the lower part of the right side.
•
Turn the knob.
When a CCP-6224 or CCP-6324 control panel
including a Multifunction Flexi Pad control block is
connected, the display in the button area at the lower
part of the status area changes as follows.
The left side of the status area shows region selection
buttons; the upper part of the right side shows a list of
regions assigned to region selection buttons, and the
lower part shows a list of assignable regions.
2
To assign regions to the region selection buttons in the
Multifunction Flexi Pad control block or the numeric
keypad buttons in the memory recall section, press
either of the following buttons in the <Flexi Pad Area
Sel> group of the button area.
Region Sel Btn Area: When assigning a region to the
region selection buttons
Mem Rcl Btn Area: When assigning a region to the
numeric keypad buttons in the memory recall
section
3
Press the indication of the button for the assignment.
The button you pressed appears in reverse video.
4
Using any of the following methods, select one of the
four regions for the setting.
•
Press directly on the list in the upper part of the right
side.
•
Press the arrow keys to scroll the reverse video
cursor in the list in the upper part of the right side.
•
Turn the knob.
Selection to
which setting
applies
5
Using any of the following methods, select the region
to be assigned.
•
Press directly on the list in the lower part of the right
side.
6
Press [Set], to confirm the selection.
This assigns the region to the region selection button
in the numeric keypad control block.
Notes
Only regions assigned here can be used for keyframe or
snapshot recall.
If an M/E bank is not assigned to a region selection button
in the numeric keypad control block, the M/E Flexi Pad
control block cannot be used to recall a snapshot.
To return the region assignment to the factory
default state
In the Panel >Config >10 Key Region Assign menu, press
[Default].
This returns the assignment of region selection buttons in
the numeric keypad control block to the factory default
state.
To delete a region assignment
In step 3 of the procedure “Assigning a Region to the
Region Selection Buttons in the Numeric Keypad Control
Block or Multifunction Flexi Pad Control Block” (page
570), make the selection to which the operation applies,
then press [Clear].
This clears the assignment of the selected region.
Setting the region selection buttons selected when the [ALL] button is pressed
1
In the Panel >Config >10 Key Region Assign menu,
press [All Select] in the button area, or the [All Select]
button indication in the status area, setting it to On.
The [All Select] button indication in the status area
changes to orange, and the system switches to a mode
for assigning region selection buttons to the [ALL]
button. In the factory default state, all buttons appear
in reverse video, and are assigned to the [ALL] button.
2
If you do not want to assign any region selection
button to the [ALL] button, press the corresponding
button indication, setting it to Off.
The button you pressed returns to normal display.
To Next Page
Loading...
