Sony MVS-8000X SystemMVS-7000X System - Page 647

USO RESTRITO
Serial Port Settings (Serial Port Assign Menu) 647
Knob
Parameter
Adjustment
Setting values
1
Item
Item selection
1 to 16
Block
Byte
Setting item
BLOCK 1
1
HI-BYTE (DEVICE TYPE)
2
LO-BYTE (DEVICE TYPE)
3
HI-BYTE (FRAME) (PREROLL
TIME)
4
LO-BYTE (FRAME) (PREROLL
TIME)
5
EDIT DELAY (FRAME)
6
EE DELAY (FRAME)
7
OVER RUN (FRAME)
8
TRAJECTORY
Chapter
22
DCU
Setup
(DCU)
The input device name appears in the device name list.
To return the device name for the selected ID to the
default name
Press [Clear] in the <Name> group.
7 Using any of the following methods, specify the
command to which the response speed setting applies.
• Press directly on the delay list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob
Parameter
Adjustment
Setting values
2
No
Command
number
selection
1 to 18
8 Turn the knob to set the response speed (in field units) of
the device.
Knob
Parameter
Adjustment
Setting values
3
Delay
Response speed
setting
0 to 60
9 Press [Delay Set].
10Repeat steps 4 to 9 as required to make the settings for
other commands.
and timecode source appear. In the lower part of the
status area, the VTR constants appear.
4 In the <TC Source> group, select the timecode source
(reference signal for determining the tape position)
from the following.
LTC (Longitudinal Time Code): Use LTC. When
interpolation data is returned from a VTR, use that interpolation data.
LTC: VITC (Vertical Interval Time Code):
Normally use LTC, but when the tape is moving at
speeds at which LTC cannot be read, use VITC.
When interpolation data is returned from a VTR,
use that interpolation data.
VITC: Use VITC.
CTL (Control): CTL pulses or timer counter pulses
are used. Use this only for a tape on which no
timecode is recorded.
The displayed tape position is based on the reference
signal specified here.
5 Using any of the following methods, specify the VTR
constants.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Making detailed settings for a VTR
1 In the <DCU Select> group of the DCU >Serial Port
Assign menu, select the target for the setting (DCU1 or
DCU2).
2 Using any of the following methods, select the serial
port connected to the VTR for which you want to make
the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob
Parameter
Adjustment
Setting values
1
Port No
Serial port
1 to maximum
value
a)
a) The range of setting values depends on the DCU port setting. When
the MKS-2700 is connected, select 2 for the slot and a value in the
range 1 to 6 for the port.
3 Press [Port Setting].
The DCU >Serial Port Assign >VTR Setting menu
appears.
At the top of the status area, the relevant serial port,
slot number, protocol, serial port name, SCU number,
6 Press [Set].
A numeric keypad window for hexadecimal input
appears.
7 Set the VTR constants using values in the range 00 to
FF.