Chapter
2
Menus
and
Control
Panel
1
Color palette buttons
2
Operation buttons
3
Color display
4
Numeric keypad
a
Color palette buttons
Press one of these to enter the corresponding color in the
display.
By default the following settings are available.
First row: white, yellow, cyan, green
Second row: magenta, red, blue, black
Third row: all black
b
Operation buttons
Set: If you press any color palette button with this button
held down, the color shown in the color display is
assigned to the color palette button.
Copy: If you press a color palette button with this button
held down, the color is used as the source for copying.
Next press a different color palette button to copy to
that button.
Swap: If you press two color palette buttons in sequence
with this button held down, the two colors are
swapped.
Default: If you press any color palette button with this
button held down, the color palette button is set to the
default color.
c
Color display
This shows the setting color, and the parameters (LUM,
SAT, and HUE).
By adjusting the parameters with the knobs, you can create
any color.
If a parameter value is outside the permitted range for RGB
(0 to 255), the indication “Illegal Color” appears, and this
is adjusted to a value in range.
Cancel: Pressing this button returns to the state when the
color palette window was opened.
d
Numeric keypad
Use this to enter numeric values for parameters.
For details of use, see page 81.
To Next Page
Loading...
