Configuring ACL ACL Configurations
Configuration Guide
513
ACL ID Select an MAC ACL from the drop-down list.
Rule ID Specify the rule ID, which ranges from 0 to 999.
It should not be the same as any existing MAC ACL Rule IDs.
Operation Select an operation to be performed when a packet matches the rule.
Permit: To forward the matched packets.
Deny: To discard the matched packets.
2) Configure the rule’s packet-matching criteria.
S-MAC/Mask Enter the source MAC address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
D-MAC/Mask Enter the destination IP address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
3) Click Apply.
Configuring the Standard-IP ACL Rule
Choose the menu ACL > ACL Config > Standard-IP ACL to load the following page.
Figure 2-3 Creating the Standard-IP ACL Rule
Follow these steps to create the Standard-IP ACL rule:
1) Select a Standard-IP ACL from the drop-down list, enter a Rule ID, and specify the
operation for the matched packets.
ACL ID
Select a S
tandard-IP
ACL from the drop-down list.
Rule ID Specify the rule ID, which ranges from 0 to 1999.
It should not be the same as any existing
Standard-IP
ACL Rule IDs.
To Next Page
Loading...
