Configuration Guide 514
Configuring ACL ACL Configurations
Operation Select an operation to be performed when a packet matches the rule.
Permit: To forward the matched packets.
Deny: To discard the matched packets.
2) Configure the rule’s packet-matching criteria.
S-IP/Mask Specify the source IP address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
D-IP/Mask Specify the destination IP address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
3) Click Apply.
Configuring the Extend-IP ACL Rule
Choose the menu ACL > ACL Config > Extend-IP ACL to load the following page.
Figure 2-4 Creating the Extend-IP ACL Rule
Follow these steps to create the Extend-IP ACL rule:
1) Select an Extend-IP ACL from the drop-down list, enter a Rule ID, and specify the
operation for the matched packets.
ACL ID
Select a
Extend-IP ACL
ACL from the drop-down list.
Rule ID Specify the rule ID, which ranges from 0 to 1999.
It should not be the same as any existing
Extend-IP ACL
ACL Rule IDs.
Operation Select an operation to be performed when a packet matches the rule.
Permit: To forward the matched packets.
Deny: To discard the matched packets.
To Next Page
Loading...
