Configuring ACL ACL Configurations
Configuration Guide
515
2) Configure the rule’s packet-matching criteria
.
S-IP/Mask Specify the source IP address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
D-IP/Mask Specify the destination IP address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
IP Protocol Select a protocol type from the drop-down list. The default is All, which
indicates that packets of all protocols will be matched.
S-Port / D-Port Enter the TCP/UDP source and destination port if TCP/UDP protocol is
selected. The port number ranges from 0 to 65535.
3) Click Apply.
Configuring the IPv6 ACL Rule
Choose the menu ACL > ACL Config > IPv6 ACL to load the following page.
Figure 2-5 Creating the IPv6 ACL Rule
Follow these steps to create the IPv6 ACL rule:
1) Select an IPv6 ACL from the drop-down list, enter a Rule ID, and specify the operation
for the rule.
ACL ID Select an IPv6 ACL from the drop-down list.
Rule ID Specify the rule ID, which ranges from 0 to 999.
It should not be the same as any existing IPv6 ACL Rule IDs.
To Next Page
Loading...
