Zeiss Humphrey II-i series - Page 523

Humphrey Field Analyzer II- i series User Manual 2660021145640 A
Networking Reference
I-33
Table I.4 General Networking Error Messages
Error Message Possible Solution
A hard drive database failure has occurr
ed. The hard drive
database must be repaired before backup to file server can be
performed.
• Refer to “How to Handle Database Failures,” on page 11-10.
A hard drive database failure has occurr
ed. The hard drive
database must be repaired before restore from file server can
be performed.
• Refer to “How to Handle Database Failures,” on page 11-10.
A hard drive database failure has occurr
ed. The hard drive
database must be repaired before archiving can be
performed.
• Refer to “How to Handle Database Failures,” on page 11-10.
A hard drive database failure has occurr
ed. The hard drive
database must be repaired before data retrieval can be
performed.
• Refer to “How to Handle Database Failures,” on page 11-10.
A network address must be of the form XXX.XXX.XXX.XXX
wher
e XXX is a number between 0 and 255.
• Re-enter the IP address in the correct format.
Cannot access the remote host. Check network connection
and
try again.
• Check all cable connections.
• Verify the server is powered up and running.
• Verify accuracy of the IP address for your server and re-enter the
addr
ess, if necessary.
Cannot access the specified folder
. Check permissions and try
again.
• Verify that the user has access privileges for the specified folder.
• Change to a folder for which you have access privileges.
Cannot find server. Check network connection and settings
and
try again.
• Check all cable connections.
• Verify the server is powered up and running.
• Verify accuracy of the IP address for your server and re-enter the
addr
ess, if necessary.
Cannot find specified folder. Ensure folder exists on the server
and
try again.
• Verify that the specified folder exists on the network server.
• Ensure that you have not misspelled the folder name.
• Re-enter the folder name or use a different folder.
Cannot login to server. Check user name and password and
try aga
in.
• Re-enter your User Name and Password for the server.
• If problem persists, verify User Name and Password with the
System
Administrator.
Cannot write to remote folder. Check permissions on the
server and
try again.
• Verify that you have write-access to the specified folder.
• Get needed write-access privilege
s from System Administrator.
Could not obtain IP address from the DHCP server. • Check all cable connections.
• Verify the server is powered up and running.
• Verify accuracy of the IP address for your server and re-enter the
addr
ess, if necessary.