Datalogic Magellan 1500i - Standard 2 of 5 Check Character Calculation

STANDARD 2 OF 5 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 251
Standard 2 of 5 Check Character Calculation
Enables/disables calculation and verification of an optional Standard 2 of 5 check character.
NOTE
If check character calculation is disabled, the risk is increased
that a misread can occur. When disabled, any check character in
a barcode is treated as data character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
049600(CR)
Standard 2 of 5 Check Character Calculation = Disable
049601(CR)
Standard 2 of 5 Check Character Calculation = Enable
DEFAULT