ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
35
Center Zone Size
Specifies the Center Zone size as a percentage of the full image.
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
Set Center Zone Size below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Scan the appropriate digits from the
Alpha-Numeric Keypad in Appendix C that repre‐
sent the desired percentage in hex. The selectable range is 01 ‐ 100%. P
ad all numbers
with leading zeros to yield a two‐digit entry (01‐100).
4. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
Set Center Zone Size
Default setting for this feature is: 10 percent
DEFAULT
To Next Page
Loading...
