ENTER/EXIT PROGRAMMING MODE
44
MAGELLAN™ 1500I
Good Read LED Idle State
This feature specifies the state of the green scanner LEDs when the scanner is idle and
ready to read a label. Options are:
•Off
• On dim
To set the Scanner LEDs Idle State:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
Scanner LED Idle State = Off
Scanner LED Idle State = On Dim
To Next Page
Loading...
