PRODUCT REFERENCE GUIDE
329
APPENDIX F
HOST COMMANDS
ACCEPTING RS-232 AND USB COM COMMANDS
The scanner responds to the following RS‐232 and USB COM commands:
COMMAND ASCII HEX COMMENT
Enable Scanner E 0x45
Disable
Scanner
D 0x44
Reset Scanner R 0x52
Not On File Indication F 0x46 Long series of beeps
Beep Good Read Tone B 0x42
Beeps if Good Read Beep is
en
abled
Force Good Read
To
ne
n/a 0x01
Beeps regardless of beep set-
ting
Identification request i 0x69
Returns long response
a
a. Call Tech Support for information.
Health request h 0x68
Returns long response
a
Status request s 0x73
Returns long response
a
Beep on ASCII BEL ! 0x07
Beeps if Beep on ASCII BEL is
en
abled
If one of the above commands is received, the scanner will perform the steps indicated for
the command. Host commands for other interfaces are also available. Contact Tech Support
for more details.
Information about additional features can be found in "
Service Port Mode" on page 23 and
"Image Capture to the Host by Host Command" on page 57.
To Next Page
Loading...
