ENTER/EXIT PROGRAMMING MODE
112
MAGELLAN™ 1500I
Setting Label ID
This feature allows the setting of custom Label ID character(s) for each available symbology
type if other than the default Label ID is desired.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode for the desired symbology. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the Alpha-Numeric Keypad on page 305 that repre‐
sent the desired Label ID characters; entered as two hex pairs. A table containing the
ASCII Character Set and their corresponding Hex Values is available in the inside back
cover of this manual. ASCII parameters must be input by scanning a pair of hexadeci
‐
mal digits for each character. Thus, to set a two‐character value of AB, barcodes con‐
taining the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable range for this
option is any hex value from 00 to FF.
Complete the programming sequence by scanning the Enter/Exit Programming Mode barcode.
To Next Page
Loading...
