Datalogic Magellan 1500i - Code 39 Check Character Calculation

ENTER/EXIT PROGRAMMING MODE
198 MAGELLAN™ 1500I
Code 39 Check Character Calculation
Enables/disables calculation and verification of an optional Code 39 check character. When
disabled, any check character in label is treated as a data character.
NOTE
If check calculation is disabled, the risk is increased that a mis-
read can occur.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
005500(CR)
Code 39 Check Character Calculation = Disable
005501(CR)
Code 39 Check Character Calculation = Enable
DEFAULT