Datalogic Magellan 1500i - Codabar Start Stop Character Set

ENTER/EXIT PROGRAMMING MODE
228 MAGELLAN™ 1500I
Codabar Start Stop Character Set
This feature specifies the format of transmitted Codabar start/stop characters.
Options are:
•ABCD/TN* E
•ABCD/ABCD
• abcd/tn* e
• abcd/abcd
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below or from the following page representing the desired option.
Y
ou’ll need to cover any unused barcodes and facing pages to ensure that the scanner
reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
022E00(CR)
Codabar Start Stop Character Set = ABCD/TN* E
022E01(CR)
Codabar Start Stop Character Set = ABCD/ABCD
022E02(CR)
Codabar Start Stop Character Set = abcd/tn* e
022E03(CR)
Codabar Start Stop Character Set = abcd/abcd
DEFAULT