Datalogic Magellan 1500i - Code 39 Check Character Transmission

CODE 39 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 199
Code 39 Check Character Transmission
Enables/disables transmission of optional Code 39 check character.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
008A00(CR)
Code 39 Check Character Transmission = Disable
008A01(CR)
Code 39 Check Character Transmission = Enable
DEFAULT