Datalogic Magellan 1500i - Standard 2 of 5 Check Character Transmission

ENTER/EXIT PROGRAMMING MODE
252 MAGELLAN™ 1500I
Standard 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Standard 2 of 5 check character.
NOTE
This feature applies only when Standard 2 of 5 Check Character
Calculation on page 251
is enabled. This item is ignored when the
advanced feature, Full Label Edit, is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
049B00(CR)
Standard 2 of 5 Check Character Transmission = Dis-
able
049B01(CR)
Standard 2 of 5 Check Character Transmission = Enable
DEFAULT