Datalogic Magellan 1500i - Australia Post; Australian Post Enable

AUSTRALIA POST ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 287
AUSTRALIA POST
Australian Post Enable
Enables/disables the ability of the scanner to decode Australia Post labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
052500(CR)
Australia Post = Disable
052501(CR)
Australia Post = Enable
DEFAULT