Datalogic Magellan 1500i - EAN-13 First Character Transmission

EAN-13 ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 141
EAN-13 First Character Transmission
Enables/disables transmission of EAN/JAN‐13 first character.
NOTE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
024400(CR)
EAN-13 First Character Transmission = Disable
024401(CR)
EAN-13 First Character Transmission = Enable
DEFAULT