CODABAR ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
229
Codabar Start Stop Character Match
Enables/disables the requirement that Codabar start and stop characters match.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
Codabar Start Stop Character Match = Disable
Codabar Start Stop Character Match = Enable
DEFAULT
To Next Page
Loading...
