ENTER/EXIT PROGRAMMING MODE
150
MAGELLAN™ 1500I
EAN-8 Guard Substitution
This setting enables the scanner to substitute a guard pattern for even‐parity 6 for EAN8/
JAN8 labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
DEFAULT
To Next Page
Loading...
