Datalogic Magellan 1500i - Digital Watermark (Digimarc) Enable; Digital Watermark (Digimarc) Features

ENTER/EXIT PROGRAMMING MODE
28 MAGELLAN™ 1500I
Digital Watermark (Digimarc) Features
Digital Watermark (Digimarc) Enable
Enables/Disables the ability of the scanner to decode Digital Watermarks.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
NOTE
049000(CR)
Digital Watermark (Digimarc) = Disable
049001(CR)
Digital Watermark (Digimarc) = Enable
The Digital Watermark feature must be enabled for decode functionality.
DEFAULT