Datalogic Magellan 1500i - Good Read Beep Frequency

ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 47
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high frequency (controls
the beeper’s pitch/tone).
•Low
• Medium
• High
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
001400(CR)
Good Read Beep Frequency = Low
001401(CR)
Good Read Beep Frequency = Medium
001402(CR)
Good Read Beep Frequency = High
DEFAULT