Datalogic Magellan 1500i - QR Code; QR Code Enable

QR CODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 271
QR CODE
QR Code Enable
Enables/disables the ability of the scanner to decode QR Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
03D700(CR)
QR Code = Disable
03D701(CR)
QR Code = Enable
DEFAULT