Datalogic Magellan 1500i - Center Zone Enable

ENTER/EXIT PROGRAMMING MODE
34 MAGELLAN™ 1500I
Center Zone Enable
Enables or Disables Center Zone Label Proofing. In "Always On" mode, Zone Proofing will be
applied to labels presented to the scanner while in Active State and in HandHeld State.
NOTE
Labels rendered by segment assembly carry no coordinate data, and will not
be pr
oofed if Center Zone Label Proofing is enabled.
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
150300(CR)
Center Zone Proofing = Disable
150301(CR)
Center Zone Proofing = On only when in ScannerActive-
Mode/ HandheldState
150302(CR)
Center Zone Proofing = Always on
DEFAULT