Datalogic Magellan 1500i - 2 D Inverse Read Control

ENTER/EXIT PROGRAMMING MODE
32 MAGELLAN™ 1500I
2D Inverse Read Control
This configuration item is used to toggle inverted label reading for 2D barcodes, for exam‐
ple, a label printed as white on black as opposed to black on white.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar
code.
040C00(CR)
2D Inverse Read Control = Disable
040C01(CR)
2D Inverse Read Control = Enable
DEFAULT