ENTER/EXIT PROGRAMMING MODE
192
MAGELLAN™ 1500I
DataBar Expanded Length Control
This feature specifies either variable‐length or fixed‐length decoding for DataBar Expanded.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar
code.
DataBar Expanded Length Control = Variable Length
DataBar Expanded Length Control = Fixed Length
DEFAULT
To Next Page
Loading...
