38 Dolby
®
IMS2000 Installation and User’s Manual
IMS.OM.004730.DRM Issue 2
Figure 6-7 Hard-Disk Drives Inserted
6.3 Connecting Audio Cables
You must connect the audio cables to the Dolby
®
IMS2000 unit.
Figure 6-8 Audio Connectors
To connect the audio cables:
1. Connect one end of the shielded CAT5 or CAT6 cable to the AES-OUT 1-8 connector
on the IMS2000 board.
2. Connect the other end of the shielded CAT5 or CAT6 cable to the audio processor.
3. Take another shielded CAT5 or CAT6 cable, and connect it to the AES-OUT 9-16
connector on the IMS2000 board.
4. Plug the other end of the shielded CAT5 or CAT6 cable to the audio processor.
Figure 6-9 RJ-45 to 25-Pin D-Connector Converter
To Next Page
Loading...
