Dolby
®
IMS2000 Installation and User’s Manual
IMS.OM.004730.DRM Issue 3 35
Chapt er 6 Installing and Marrying an IMS2000
with a Barco Series 2 Projector
Before you begin to install the IMS2000 into your projector, be sure that:
• The projector is powered down and in the off position.
• The AC power cord is disconnected from the wall.
• You always follow electrostatic discharge procedures.
6.1 Preparation
You must prepare the projector prior to installing the IMS2000.
Figure 6-1 Barco Projector
To Next Page
Loading...