Dolby
®
IMS2000 Installation and User’s Manual
IMS.OM.004730.DRM Issue 3 51
7.4 Connecting GPI/GPO Cables
Figure 7-11 Audio Connectors
1. Connect one end of the shielded CAT5 or CAT6 cable to the connector labeled GPI on
the IMS2000 board.
Connect the other end of the shielded CAT5 or CAT6 cable into whichever
automation controller is available or required.
2. Take another shielded CAT5 or CAT6 cable, and connect it into the connector labeled
GPO.
Connect the other end of the shielded CAT5 or CAT6 cable into an automation
controller that is available or required.
To Next Page
Loading...
