C
HAPTER
5
| Interface Configuration
Trunk Configuration
– 142 –
To configure LACP parameters for group members:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Configure from the Action list.
4. Click Actor or Partner.
5. Configure the required settings.
6. Click Apply.
Figure 39: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Show Member from the Action List.
4. Select a Trunk.
Figure 40: Showing Members of a Dynamic Trunk
To Next Page
Loading...
Need help?
General
