C
HAPTER
7
| Address Table Settings
Configuring MAC Address Learning
– 188 –
◆ Also note that MAC address learning cannot be disabled if any of the
following conditions exist:
■
802.1X Port Authentication has been globally enabled on the switch
(see "Configuring 802.1X Global Settings" on page 314).
■
Security Status (see "Configuring Port Security" on page 311) is
enabled on the same interface.
PARAMETERS
These parameters are displayed in the web interface:
◆ Interface – Displays a list of ports or trunks.
◆ Port – Port Identifier. (Range: 1-26/50)
◆ Trunk – Trunk Identifier. (Range: 1-32)
◆ Status – The status of MAC address learning. (Default: Enabled)
WEB INTERFACE
To enable or disable MAC address learning:
1. Click MAC Address, Learning Status.
2. Set the learning status for any interface.
3. Click Apply.
Figure 78: Configuring MAC Address Learning
To Next Page
Loading...
