C
HAPTER
13
| Security Measures
Configuring the Secure Shell
– 280 –
client to select either DES (56-bit) or 3DES (168-bit) for data
encryption.
N
OTE
:
The switch uses only RSA Version 1 for SSHv1.5 clients and DSA
Version 2 for SSHv2 clients.
◆ Save Host-Key from Memory to Flash – Saves the host key from
RAM (i.e., volatile memory) to flash memory. Otherwise, the host key
pair is stored to RAM by default. Note that you must select this item
prior to generating the host-key pair. (Default: Disabled)
WEB INTERFACE
To generate the SSH host key pair:
1. Click Security, SSH.
2. Select Configure Host Key from the Step list.
3. Select Generate from the Action list.
4. Select the host-key type from the drop-down box.
5. Select the option to save the host key from memory to flash if required.
6. Click Apply.
Figure 146: Generating the SSH Host Key Pair
To display or clear the SSH host key pair:
1. Click Security, SSH.
2. Select Configure Host Key from the Step list.
3. Select Show from the Action list.
4. Select the host-key type to clear.
5. Click Show.
To Next Page
Loading...
Need help?
General
