C
HAPTER
13
| Security Measures
Filtering IP Addresses for Management Access
– 310 –
◆ You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
PARAMETERS
These parameters are displayed in the web interface:
◆ Mode
■
Web – Configures IP address(es) for the web group.
■
SNMP – Configures IP address(es) for the SNMP group.
■
Telnet – Configures IP address(es) for the Telnet group.
◆ Start IP Address – A single IP address, or the starting address of a
range.
◆ End IP Address – The end address of a range.
WEB INTERFACE
To create a list of IP addresses authorized for management access:
1. Click Security, IP Filter.
2. Select Add from the Action list.
3. Select the management interface to filter (Web, SNMP, Telnet).
4. Enter the IP addresses or range of addresses that are allowed
management access to an interface.
5. Click Apply
Figure 168: Creating an IP Address Filter for Management Access
To Next Page
Loading...
