C
HAPTER
13
| Security Measures
Configuring 802.1X Port Authentication
– 315 –
PARAMETERS
These parameters are displayed in the web interface:
◆ Port Authentication Status – Sets the global setting for 802.1X.
(Default: Disabled)
◆ EAPOL Pass Through – Passes EAPOL frames through to all ports in
STP forwarding state when dot1x is globally disabled.
(Default: Disabled)
When this device is functioning as intermediate node in the network
and does not need to perform dot1x authentication, EAPOL Pass
Through can be enabled to allow the switch to forward EAPOL frames
from other switches on to the authentication servers, thereby allowing
the authentication process to still be carried out by switches located on
the edge of the network.
When this device is functioning as an edge switch but does not require
any attached clients to be authenticated, EAPOL Pass Through can be
disabled to discard unnecessary EAPOL traffic.
WEB INTERFACE
To configure global settings for 802.1X:
1. Click Security, Port Authentication.
2. Select Configure Global from the Step list.
3. Enable 802.1X globally for the switch, and configure EAPOL Pass
Through if required. Then set the user name and password to use when
the switch responds an MD5 challenge from the authentication server.
4. Click Apply
Figure 172: Configuring Global Settings for 802.1X Port Authentication
To Next Page
Loading...
Need help?
General
