EasyManua.ls Logo

Edge-Core ECS4610-24F

Edge-Core ECS4610-24F
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C
HAPTER
13
| Security Measures
IP Source Guard
– 324 –
If there is an entry with the same VLAN ID and MAC address, and
the type of entry is static IP source guard binding, then the new
entry will replace the old one.
If there is an entry with the same VLAN ID and MAC address, and
the type of the entry is dynamic DHCP snooping binding, then the
new entry will replace the old one and the entry type will be
changed to static IP source guard binding.
Only unicast addresses are accepted for static bindings.
PARAMETERS
These parameters are displayed in the web interface:
Port – The port to which a static entry is bound.
VLAN – ID of a configured VLAN (Range: 1-4093)
MAC Address – A valid unicast MAC address.
IP Address – A valid unicast IP address, including classful types A, B
or C.
WEB INTERFACE
To configure static bindings for IP Source Guard:
1. Click Security, IP Source Guard, Static Configuration.
2. Select Add from the Action list.
3. Enter the required bindings for each port.
4. Click Apply
Figure 176: Configuring Static Bindings for IP Source Guard

Table of Contents

Other manuals for Edge-Core ECS4610-24F

Related product manuals