C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 359 –
PARAMETERS
These parameters are displayed in the web interface:
◆ Remote Engine ID – The engine ID can be specified by entering 9 to
64 hexadecimal characters (5 to 32 octets in hexadecimal format). If
an odd number of characters are specified, a trailing zero is added to
the value to fill in the last octet. For example, the value “123456789” is
equivalent to “1234567890”.
◆ Remote IP Host – The IP address of a remote management station
which is using the specified engine ID.
WEB INTERFACE
To configure a remote SNMP engine ID:
1. Click Administration, SNMP.
2. Select Configure Engine from the Step list.
3. Select Add Remote Engine from the Action list.
4. Enter an ID of a least 9 hexadecimal characters, and the IP address of
the remote host.
5. Click Apply
Figure 197: Configuring a Remote Engine ID for SNMP
To show the remote SNMP engine IDs:
1. Click Administration, SNMP.
2. Select Configure Engine from the Step list.
3. Select Show Remote Engine from the Action list.
To Next Page
Loading...
Need help?
General
