C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 369 –
4. Enter a name and assign it to a group. If the security model is set to
SNMPv3 and the security level is authNoPriv or authPriv, then an
authentication protocol and password must be specified. If the security
level is authPriv, a privacy password must also be specified.
5. Click Apply
Figure 207: Configuring Local SNMPv3 Users
To show local SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Local User from the Action list.
Figure 208: Showing Local SNMPv3 Users
To Next Page
Loading...
