C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 371 –
◆ Privacy Password – A minimum of eight plain text characters is
required.
WEB INTERFACE
To configure a remote SNMPv3 user:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Add SNMPv3 Remote User from the Action list.
4. Enter a name and assign it to a group. Enter the IP address to identify
the source of SNMPv3 inform messages sent from the local switch. If
the security model is set to SNMPv3 and the security level is authNoPriv
or authPriv, then an authentication protocol and password must be
specified. If the security level is authPriv, a privacy password must also
be specified.
5. Click Apply.
Figure 209: Configuring Remote SNMPv3 Users
To show remote SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Remote User from the Action list.
To Next Page
Loading...
