C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 373 –
3. Create a view with the required notification messages (page 360).
4. Create a group that includes the required notify view (page 363).
5. Enable trap informs as described in the following pages.
PARAMETERS
These parameters are displayed in the web interface:
SNMP Version 1
◆ IP Address – IP address of a new management station to receive
notification message (i.e., the targeted recipient).
◆ Version – Specifies whether to send notifications as SNMP v1, v2c, or
v3 traps. (Default: v1)
◆ Community String – Specifies a valid community string for the new
trap manager entry. (Range: 1-32 characters, case sensitive)
Although you can set this string in the Configure Trap – Add page, we
recommend defining it in the Configure User – Add Community page.
◆ UDP Port – Specifies the UDP port number used by the trap manager.
(Default: 162)
SNMP Version 2c
◆ IP Address – IP address of a new management station to receive
notification message (i.e., the targeted recipient).
◆ Version – Specifies whether to send notifications as SNMP v1, v2c, or
v3 traps.
◆ Notification Type
■
Traps – Notifications are sent as trap messages.
■
Inform – Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps
are used)
■
Timeout – The number of seconds to wait for an
acknowledgment before resending an inform message.
(Range: 0-2147483647 centiseconds; Default: 1500
centiseconds)
■
Retry times – The maximum number of times to resend an
inform message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
◆ Community String – Specifies a valid community string for the new
trap manager entry. (Range: 1-32 characters, case sensitive)
To Next Page
Loading...
